Tried and True: Use a Boat Shuttle for Rag Weaving

Wind very narrow fabric strips on quills and put them in a boat shuttle. It’s efficient. It’s faster to wind a quill than to load fabric on a ski shuttle. Plus, I like the advantage of sending a boat shuttle across rather than a ski shuttle. This rag rug on the drawloom has fabric strips that are only one centimeter (~3/8”) wide, instead of the usual two-centimeter-wide (~3/4”) strips for an ordinary rag rug. Grab your boat shuttle and pay attention to a few simple tips. Your very narrow fabric strips will be woven up in no time.

Tips for Using a Boat Shuttle to Weave Very Narrow Fabric Strips

  • Use fabric that has minimal fraying at the edges. Trim off any long threads. Loose dangling threads that are long enough to wind themselves on the quill will make you wish you had used a ski shuttle.
  • Wind the fabric with the right side down. Then, when the quill unrolls, the right side will be facing up.
Winding quills with narrow fabric strips. Rag rug on the drawloom.
Swedish bobbin winder is clamped to the side of the loom. A five-yard fabric strip is wound onto a quill. The right side of the fabric is against the quill.
  • Handle the wound quill as little as possible to prevent fraying the fabric edges. Simply wrap the tail end of the fabric strip around the filled quill. Do not wrap the end into a slip knot around the quill because the fabric will fray as you release the knot.
Winding narrow fabric strips on quills for drawloom rag rug.
One long fabric strip per quill. Fabric is cut 1 cm (3/8″) wide.
Fabric-wound quills ready for weaving drawloom rag rug.
One fabric-filled quill covers a little more than one unit of weaving (4 picks). I keep a dozen filled quills in the basket on my loom bench so I can keep weaving as long as possible.
  • Unwind enough weft for the pick before you throw the shuttle. Pull the weft out straight from the quill. When a quill unwinds in the shed, the weft comes off at an angle. And as such, if there are any loose threads at the edges of the fabric strips, the threads will wind themselves on the quill and bind it up. And you will wish you had used a ski shuttle.
Folke Samuelson Damask Shuttle - drawloom rag rug!
Folke Samuelson Damask Shuttle has a low profile, well-suited for the smaller sheds of the drawloom. Fabric is unrolled from the shuttle prior to the next pick.
Design is "Trasmatta Snöfall" ("Snowfall Rag Rug") by Kerstin Åsling-Sundberg, from Damast, Horlags AB Vavhasten
Drawloom rag rug is well underway. Single unit drawcords are pulled and held in place on the pegs above the beater. Design is Trasmatta Snöfall (Snowfall Rag Rug) by Kerstin Åsling-Sundberg, from Damast, edited by Lillemor Johansson.

May your hands enjoy their work.

Happy Weaving,
Karen

10 thoughts on “Tried and True: Use a Boat Shuttle for Rag Weaving

    1. Hi Geri, This design is good for a single-unit beginner like me. Very simple. But I think the outcome will be quite impressive, as you say.

      Happy weaving,
      Karen

    1. Hi Ellen, As with any rag rug, yes, the weft will shed threads as it is walked on. My main concern about keeping the fabric edges from fraying is so the fabric strips will roll off the quill unhampered.

      Happy New Year,
      Karen

    1. Hi Betsy, The color is very pleasant, with subtle variations. I am also going to introduce some more shades along the length of the rug.

      Thanks!
      Karen

  1. Good morning Karen,
    Beautiful.
    About 5 years ago I bought a tabby woven rag rug with the warp deliberately saw cut at a craft show. The result was/is a shaggy rug. the first few washings freed the loose ends. Now it has settled.

    Your post is on the other end of the spectrum of rag rug weaving. I love it.

    Thank you.

Leave a Reply to Karen Cancel reply

Your email address will not be published. Required fields are marked *