Check for Accuracy Now or Backtrack Later

It pays to check your work. I have reached a new level of experience in distributing patterns shafts. I know how to do it backwards and forwards now. Literally. Unfortunately, I moved almost all of the pattern shafts before noticing that the spacing between units is not quite right. Uh oh! So, one by one, I reversed the distribution of pattern shafts to get back to the point of error—the very beginning. The reverse move was …more complicated.

Distribution of pattern shafts is part of the setup for the drawloom. It is a multi-step process that moves the pattern shafts, one at a time, from the heddle bar at the back of the loom to the pattern shaft holders just behind the ground shafts at the front of the loom. Sound complicated? It’s not that hard, and is fun to do after you’ve done it a few times.

Lesson learned: Check my work. I am off by only one unit of threads. That small miss, however, is enough to sabotage the whole project if not corrected. The sooner I check my work against the master plan the better. Fortunately, everything at the loom is fixable. It’s never too late to start again.

First, I use an old inkle band to slip between heddles that I am separating to transfer to a pattern shaft. Because I am using a combination of pattern shafts AND single units, I separate the heddles on the “front” side. If I were usining only pattern shafts and no single units, I could separate the heddles from the back while standing behind the loom.
I insert a pattern shaft through the separated pattern heddles. Then I remove the inkle band and hang it around my neck, ready for the next transfer.
I slip the waiting heddle bar through the pattern shafts that have not been separated…
…and remove the first heddle bar. This releases the separated pattern heddles onto the pattern shaft, which is hanging in a pair of holding cords. From here, the pattern shaft is moved forward to the pattern shaft holders. (I also adjust the clip overhead that connects the thread unit to a single unit draw cord.)
After backtracking and starting over, I now diligently check the number and spacing of units on the heddle bar after every pattern shaft is moved into position. Success!
Twelve pattern shafts, plus one X shaft. This project uses pattern shafts for the borders only – top, bottom, and sides. The rest of the pattern areas will use single-unit designs.

The sooner I check my life against God’s master plan the better. Fortunately, everything is forgivable. It’s never too late to start again.

All set and ready to go! Everything works. After a bit more testing of weft colors and patterns, it’s critter time. Watch for Mr. Armadillo first!

May you check for accuracy sooner than later.

Be blessed,
Karen

Creative Handweavers Need Persistence

It’s good for a handweaver to flow in creativity. That’s where designs, colors, and out-of-the-box thinking thrive. Add the virtue of persistence, and those creative ideas become tangible articles of cloth. Making things takes more persistence than it does creativity.

Threading pattern heddles. 22/2 cottolin warp.

Threading pattern heddles is a repetitive task that I enjoy. I find greater joy, though, in the actual weaving phase of the project. That is when I get to sit at this marvelous instrument and challenge my hands and feet to work together to make the glorious sounds of a loom producing patterned cloth. It does take persistence to get to that point. Even when weaving, my focus is on the outcome – creative napkins for our family meals. The end purpose not only drives my persistence to the finish line, it brings enjoyment to each necessary task along the way.

Will be napkins with fun designs. Green, with gold borders, and various linen weft colors.
Near the halfway point of threading pattern heddles. Six ends per unit.

You and I are God’s creative work. He is persistent in the forming of our character, desiring to weave the image of Christ in us. His end purpose brings meaning to all the steps it takes to complete the fabric. Imagine his enjoyment every time we allow his hands to do each necessary task.

May your persistence out pace your creativity.

Blessings,
Karen

Combination Drawloom – Simple and Engaging

I am constantly improving my methods of operating the drawloom. I pull and release draw handles and draw cords, check for errors, and throw the shuttle for each unit of threads (six times per unit with the current setup). Everything is in order. And, while I’m actively absorbed with this mental and physical choreography, I experience freedom from every other care.

Hem of towel is bleached 16/1 linen weft, and then green 16/2 linen weft. The pattern area of the towel is woven with royal blue 16/1 linen weft.
Solid row of pattern across the warp requires that all pattern shaft draw handles are pulled. It always seems thrilling to me to see all the handles down at once!
Lower border of the towel is the easy part. Pattern shafts are used for making a repeated pattern, and no single unit cords are involved.
Pattern shaft draw handles are now relegated to the side borders. The center body of the towel uses single unit draw cords to create non-repeated pattern. The single units give me freedom to design a (planned) random snowfall expression.
Snowflake Towel 01 is wrapping around the cloth beam. Snowflake Towel 02 is going over the knee beam. Snowflake Towel 03 is being woven. Snowflake Towel 04 will be the final towel on this warp. (But, who knows what I’ll be able to weave after that to the very end of the warp?)

These snowflake patterns are delightful to weave. There is enough consistency with the border pattern shafts to make it simple. And there is enough (planned) random snowflakes using single units and pattern shafts to keep it engaging. All I have to do is follow the graphed chart. As I weave, the snowflakes emerge, as if by magic. But it’s not really magic, is it?

Standard procedure is to always have a temple in place. I have rubber bands on the first and last draw handles for the side border pattern, and on the center handle for the border pattern (not pulled in this photo).
Everything works together! …for the good of the fabric being woven.
Sometimes one single unit is enough to make the next row of pattern.
I keep the chart at eye level and constantly refer to it. Closely following the chart is the only way I can hope to weave something worthwhile on the combination drawloom.

If you believe in Jesus you must walk with him. And as you do, you come to know the truth. Truth is found by walking in it. The pattern on the chart is true, and gives direction. The delight comes as we see the real-time results emerge in our own hearts. That’s freedom in its purest form.

May your search for truth bring freedom.

Happy Weaving,
Karen

Drawloom – Snow Falling

Snow in Texas Hill Country is minimal. To make up for it, I am putting together a virtual snowstorm—four Christmas Snowflake towels on the drawloom. Each towel has three large snowflakes at the bottom and top borders. The body of the towel has delicate snowflake crystals drifting to the ground.

Nordic star pattern used for Christmas Snowflake towels. Towel begins with a broad brush of red along the lower border.

Starting with Selbu Mittens: Discover the Rich history of a Norwegian Knitting Tradition, by Anne Bårdsgård, I transpose Nordic star patterns into drawloom graphed designs. Affinity Designer (graphic design software) takes the place of graph paper for me. Being vector graphic design, it enables me to make changes without having to start over. I can easily move, separate, copy, and/or transform elements as I work through a design. I print out exactly what I need, scaled up in size without losing clarity, in a format that enhances my ability to make the right moves at the combination drawloom.

Single unit draw cords, held in place on the hook bar, form the snow crystals in the body of the towel. The three large snowflakes at the bottom border are made using pattern shafts. The simple side borders also use pattern shafts.
In Affinity Designer I am able to separate, copy, and move elements of the large snowflake design. These individual elements become the scattered snowflakes and little snow crystals that are “drifting down” the body of the towel.
Snowfall in Texas Hill Country.

We have a faithful designer. Our Grand Weaver creates his image in us. He moves, separates, copies, and transforms elements in our lives until his image clearly shows. It takes a lifetime. The Lord is faithful. Since he has brought us this far, let us also be found faithful to him, conforming to his image.

May you see how far you’ve come.

Many blessings,
Karen

Typical Questions for a New Warp

I have questions galore as I begin a new warp on the combination drawloom. Is this the best sett for these threads? How are my sheds? What will orange-ey weft colors do on this pewter and blue warp? Is the image of this first design better face up, or face down? How can I include a couple extra colors in the design? The loom is set up with 45 pattern shafts and 148 single units. I’m eager to begin!

Combo drawloom with 45 pattern shafts and 148 single units.
New drawloom warp.
Myrehed Combo Drawloom attachment.

Sampling at the beginning of the warp gives me answers. The sett is good—18 ends per centimeter, with 16/2 cotton in 6-shaft irregular satin. After some tweaking, the sheds are good—and all the treadles touch the floor when the optimum shed is reached. The weft colors look good—better than expected. And, definitely, the jam jars need to be face down—so, I reverse the image in Affinity Designer on the computer and print out a new chart. I can sneak in some extra colors with narrow weft stripes—beginning and ending borders. I’m ready to roll! New kitchen towels in various designs are moving forward! First up…Peach Jam Jars.

Testing colors on new drawloom warp.
Mirror shows reversed side of drawloom fabric.
Jam Jars drawloom pattern.
Design is reversed for the drawloom.
Testing patterns and colors on new drawloom warp.
Beginning first towel on drawloom warp.
Ready - Sett - Go! New towels on the drawloom.

~It is a joy to have you visit with me every week! It is time for my annual pause for the month of July. I’ll see you back here on Tuesday, August 3, 2021.~

Until then, may the Lord bless you and protect you; may the Lord make his face shine on you and be gracious to you; may the Lord look with favor on you and give you peace.

May your questions get answered.

Happy Weaving,
Karen